JEEP GRAND CHEROKEE WJ - REAR BUMPER

This project has been developed with the intention of creating an aesthetic, robust and body-hugging rear bumper model for Jeep WJ .

In this design we have sought the homogeneity of the shapes to achieve an aesthetic in line with the lines of the vehicle, mostly rounded.

Generally, the rear bumper models for WJ tend to protrude too far from the plan view of the vehicle, thus damaging the angles of departure. This aspect is always important in bumpers since, the better the working angles of our vehicle, the better its off-road skills will be.

In this case, being a rear unit, the exit angle is of greater importance since a bumper with unfavorable angles will not only hinder maneuvers in trial, but could also catch on the ground when leaving a step complex, making the effect of an anchor and end up deforming irreparably or tearing the fastening points of the monocoque. For this reason we have designed our model with very high ends, in order to optimize these angles.

If you look at the photographs, the sides of the bumper are raised, in order to leave as much free space as possible for our maneuvers.

But we have not only considered aesthetics and functionality. We have also taken into account the rigidity of the whole set, geometrically reinforcing the frame with the design itself and using a material thickness of 4mm.

And as usual in Rock Army, we have designed a very special system of supports, since this model of bumper will serve as the basis for the next tire carriers . Which will be attached to the bumper and will include a set of additional supports to supplement its hold to ensure the firmness of the whole set.

The bumper and the wheel support kit can be purchased separately . Thus, if at first you do not want to install wheel support and in the future you change your mind, you will have the option of mounting it later .

On the other hand, this time we have included a pair of work lights at the ends of the bumper that will be of great help in your night maneuvers and a pair of small-sized shackle holders, with the same tensile strength as our standard shank holders, 12T .

In short, this is a rear model thought and designed to meet the expectations of the most demanding users and provide an aesthetic finish to the rear of our Jeep Grand Cherokee, leaving open the possibility of mounting the wheel support in the future, forming the same set.


Soon we will offer you more information about the rear wheel supports.